The unique tangle free design of the TecTies TT1 Turbo Heavy Duty Tie is specifically designed for cavity widths up to 150mm and buildings of any height.
Fully tested to BS EN 846-5:2012 the ties meet the requirements of BS EN 845-1:2013. They also meet the requirements of Part E of the Building Regulations for type B in external walls.
All TecTies cavity wall ties are independently tested at Lucideon, a notified body number 1289, to comply with BS EN 845-1:2013. Underwritten by TZUS – Prague Notified Body Number 1020.
TT1 HEAVY DUTY WALL TIE
UKCA/CE+UKNI marked
Design Advantages
Tangle Free fully closed ends:
- Save time wasted on site separating tangled ties.
- Prevent waste and reduce unnecessary replacement costs.
- Are supplied bundled without boxes to minimise packaging materials and environmental impact, and can be stored outdoors with no deterioration.
- Eliminate the risk of injury from sharp tie ends protruding from masonry work
Impossible to install upside down due to its multi drip form
Part E Building Regulations
TT1 Ties meet the requirements of Part E of the Building Regulations for a Type B tie in external walls which states that a masonry cavity wall tie can only be used if the measured dynamic stiffness is less than 113MN/m3.
Always check with your local councils guidelines for recycling.
TT1 is a Registered Design. GB Reg. Design No. 3023874
Our retaining discs are required for partial fill cavity wall installation.
TT1 Test Results