top of page
Red Strip.jpg
STAINLESS STEEL TWO PART CAVITY WALL TIES
TTTP Anchor
Tectie TTTP banner cropped.jpg
TTTP Cirlce1.png

The unique “turn and lock” design of TecTies Two Part Tie provides a rigid connection between the two components and assists with the performance criteria for this type of tie. 


The ties are specifically designed for cavity widths exceeding 150mm where longer length ties are required. 

The inner part which is 170mm long is built into the inner leaf of the cavity wall and the outer part is fixed into the outer leaf as it is built. The length of the outer part varies dependant upon the cavity width as shown in the table to the left. An embedment of 75mm is required at each end. TecTies Two Part Ties are suitable for cavity widths up to 300mm and exceed the requirements for a Type 2 tie to BS EN 845-1:2013.

TTTP STAINLESS STEEL TWO PART CAVITY WALL TIES
TTTP Cirlce2.png
TTTP.png
UKCA black fill.png

UKNI Compliance

TTTP Test Results

All TecTies cavity wall ties are independently tested at Lucideon, a notified body number 1289 to comply with BS EN 845-1:2013.

CA15774 logo-01.jpg
ukca-black-fill.png

Be assured of our commitment to Quality and Maintaining Standards. All TecTies products are guaranteed to be manufactured from 304 Grade 18/8 Austenitic Stainless Steel and are fully CE Compliant.

Get in touch

location Icon.png
phone Icon.png

Tecties, Hague Bar Works, Hague Bar, New Mills SK22 3AT 

T: 01663 749361    F: 01663 747897

email Icon.png
  • LinkedIn

Linkedin

Send us a message

Thanks for submitting!

bottom of page